Load resistor harness for H4 LED bulb installations. Adds the resistive load required for proper operation of LED turn signals and tail lights, eliminating hyper-flashing.
Sold as an individual unit. Easy to install. Plug and play.
  • Eliminates any light failure diagnostic of CAN bus system
  • Load equivalent wattage 15W
  • (12) ohm resistors
  • Easy to install with factory connector

Information:

Compatible with H4 LED bulbs. Designed for vehicles with CAN bus or other electronic bulb-out detection systems. Verify your vehicle's bulb socket type before installation.
Attributes
Add-On N/A
Amp Draw per Bulb 1.2A @ 12V
California Proposition 65 WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
Country of Origin (Primary) CN
Current Draw@12VDC 1.2
Hazardous Material Code N
Housing Material Cast Aluminum
IP Rating IP65, IP67, IP67
Life Cycle Status Code Available to Order
Maximum Amperage 1.5
NAFTA Preference Criterion Code B
Operating Temperature -40 to 185
Operating Voltage 9-16 DC Voltage
Power Consumption 15W
Resistance 12
SDR Required Flag N
Universal Or Specific Fit Specific Fit
Voltage 9-16V, 9~16
Warranty Two (2) Year Warranty
Warranty Time 2
Wattage 15, 21
GTIN 00793888980884

Write a review.

Note: HTML is not translated.
    Bad           Good